TRACTOR

BRAKE-CLUTCH

Single pedal, right foot control.

PARKING BRAKE

Independent control linkage.

STEERING RATIO

5.5 to 1.0.

FRONT AXLE

High center clearance with attaching points for front or center mounted attachments.

SAFETY INTERLOCKS

Prevent starting engine unless transmission is in neutral and power take-off is disengaged.

POWER TAKE-OFF

At front of engine through electric clutch or from left hand side of bevel gear box through belt tightener clutch.

IMPLEMENT LIFT

Manual.

LIGHTS

Standard.

DIMENSIONS

HEIGHT (AT STEERING WHEEL)

41.0 inches.

 HEIGHT (AT DASHBOARD)

35.5 inches.

WIDTH

37.5 inches.

LENGTH

70.0 inches.

FRONT WHEEL TREAD

30.7 inches.

REAR WHEEL TREAD .

27.0 inches.

CLEARANCE (FRONT AXLE)

8.0 inches.

CLEARANCE (TRANSMISSION)

6.0 inches.

WHEEL BASE

48.1 inches.

TURNING RADIUS

80.0 inches.

 FRONT TIRES

16-6.50 x 8.

REAR TIRES

23-8.50 x 12.

ENGINE

MAKE & MODEL

Briggs & Stratton Model 243430.

TYPE

engine.

BORE

3-1/16 inches.

STROKE

3-1/4 inches.

DISPLACEMENT

23.94 cubic inches.

HORSEPOWER

10 H.P. @ 3600 R.P.M.

LUBRICATION

Splash type. 4 pint capacity.

FUEL

Regular gasoline.

FUEL TANK CAPACITY

10 quarts.

AIR CLEANER

Dual element heavy duty paper cartridge and oiled polyurethane foam. Both reusable.

CARBURETOR

Float type with idle and power mixture adjust­ments. Manual choke.

FUEL FILTER

Clear, inline replaceable filter.

SPEED CONTROL

Mechanical governor fully enclosed, running in oil. Manual speed control permits matching en­gine speed to job conditions.

VALVES

Austenitic steel intake valve. Stellite faced ex­haust valve. Stellite exhaust seat insert. Intake and exhaust valve rotators.

STARTER/GENERATOR

12 volt belt driven motor generator with 14 amp voltage regulator.

IGNITION

High tension, flywheel type magneto.

CYLINDER, PISTON

Cast iron cylinder, aluminum alloy piston with chrome plated rings.

MAIN BEARINGS

 Two shielded ball bearings. -

TYPE

Sliding spur gear -transmission with single lever dual range control.

FOUR SPEED GEAR BOX

GEARS

Carburized and hardened spur gears.

BEARINGS

Ball and needle bearings.

DUAL RANGE

Single lever, easy shifting between high and low range

LUBRICATION

1.5 quarts SAE 90.

SPEEDS @ 3600 R.P.M.

High Range

Low Range

1st - 1.6 M.P.H.

.8 M.P.H.

2nd - 3.8 M.P.H.

1.9 M.P.H.

3rd - 6.2 M.P.H.

3.1 M.P.H.

Reverse - 3.2 M.P.H.

1.6 M.P.H.

BEVEL GEAR DRIVE & POWER TAKE OFF

MITER GEARS

Case hardened spiral bevel gears.

BEARINGS

Ball and needle bearings.

SHAFTS

Hardened and ground.

LUBRICATION

1.0 pints SAE 90.

 
DIFFERENTIAL

TYPE

Spur gears with 8 planet pinions spring loaded for limited friction drag.

BRAKES

TYPE

Drum type on transmission shaft.

CLUTCH 

TYPE

 Belt tensioning.